[sdiy] Eagle

[Paul Maddox]

Peter,

I'm confused, both PCB and Schematic are open, if I open the project  
they both open, one is minimized.

  but nothing appears on the PCB (I've added one component).

Paul

On 18 Jan 2009, at 21:07, Ullrich Peter wrote:

> Hi Paul!
>
> To have the layout and schematics up to date you need to open both  
> the schematics AND layout when starting your session.
> Otherwise you only change the schematics and there will be no  
> annotation to the layout. Normally Eagle tells you that this could  
> happen if you don't open the other too.
> At least if you only open the layout and change something there will  
> be a warning.
>
> So the safest solution is starting again from your old edition -  
> open the layout and then add the changes again.
> Maybe a lot of work (depends on your changes)  but it works - you  
> can see each change will be done also in the layout.
>
> Ciao
> Peter
>
> ________________________________________
> Von: synth-diy-bounces at dropmix.xs4all.nl [synth-diy-bounces at dropmix.xs4all.nl 
> ] im Auftrag von Paul Maddox [paul.maddox.mail-list at synth.net]
> Gesendet: Sonntag, 18. Jänner 2009 21:43
> An: Synth DIY
> Betreff: [sdiy] Eagle
>
> Guys (and girls),
>
>   I've made a change to my schematic in Eagle, but how do I update
> the board layout to reflect these changes? Obviously I need to rip up
> the routing, (that I can do), but what do I do after that?
>
> Paul
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy