[sdiy] dspic programmer

[Tom Wiltshire]

I've been using a far-eastern ICD2 clone that cost $40, and it's been  
brilliant. It came with two ZIF sockets (one for 16F, one for dsPIC)  
and you can program just about anything with it. Recommended.

That said, I haven't looked into the new PICKit2. It's supposed to be  
a good tool, and a lot cheaper than Microchip's usual, I hear.

T.

On 12 Dec 2009, at 19:21, karl dalen wrote:

> Are there any DIY dsPIC programmer similar to the simple AVR's 4  
> resistor
> P-port programmer or RS232? Or should i just go and buy a Pickit2?
> (i dont want to,it violates the absolute DIY sect rules/karma). :)
>
> Reg
> KD
>
>
>       __________________________________________________________
> Går det långsamt? Skaffa dig en snabbare bredbandsuppkoppling.
> Sök och jämför priser hos Kelkoo.
> http://www.kelkoo.se/c-100015813-bredband.html?partnerId=96914325
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy