[sdiy] PCB GND planes layout advices needed...

[Tim Parkhurst]

On Mon, Dec 7, 2009 at 8:08 AM, Jean-Pierre Desrochers
<jpdesroc at oricom.ca> wrote:
>
>> I see that you have two pins for ANALOG GND, what I would do in this case
>> is dedicate one of the pins to "Quite Ground" and use that for
>> the copper pour on both top and bottom. The quite ground should carry no
>> current analog or digital and have a very low impedance to your ground
>> "Star Point Connection". This will act as a classic ground shield
>> design.

Minor correction: I'm pretty sure that's supposed to be a "Quiet Ground."

Tim (well grounded) Servo
-- 
"Sire, the church of God is an anvil that has worn out many hammers."
- H.L. Hastings