[sdiy] Divide by 10^6?

[Ingo Debus]

Am 28.08.2009 um 08:12 schrieb flightofharmony:

> The exact 10^6 is just a ballpark, I just need to slow it down
> enough to blink the LED at a visible rate. The 2^20 sounds fine to me!

Perhaps it's even easier to run another (low frequency) oscillator  
just to flash the LED. If it's a VCO then feed the additional VCO  
with the same voltage. If it's a pot-controlled oscillator ( a PCO?),  
you could use a stereo pot.

But if I wanted a flashing LED to indicate a delay time, I'd want it  
to flash exactly at the intervals according to the delay time. This  
way you could adjust the delay time on the fly to match the groove.

Ingo