[sdiy] Divide by 10^6?
Needham, Alan
Alan.Needham at centrica.com
Fri Aug 28 09:38:19 CEST 2009
A tiny microcontroller would eat this job - single chip solution.
Use the 20MHz as the micro's clock and a simple program could even
supply a couple of LED flash rates (or 4 LEDs with quadrature drives?).
-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of
flightofharmony
Sent: 28 August 2009 06:42
To: synth-diy at dropmix.xs4all.nl
Subject: [sdiy] Divide by 10^6?
Hello everyone,
I have a question for the logic & digital folk: is there a
low-component-count, off-the-shelf way to divide down from 20MHz to
20Hz?
I'm trying to add a clock rate LED to the Sound of Shadows delay module
prototype I'm working on. A cascade of six 74*90 ICs works fine, but
that's
a lot of board space just to blink an LED.
Best regards,
~flight
flight at flightofharmony.com
http://www.flightofharmony.com
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
_____________________________________________________________________
The information contained in or attached to this email is intended only for the use of the individual or entity to which it is addressed. If you are not the intended recipient, or a person responsible for delivering it to the intended recipient, you are not authorised to and must not disclose, copy,distribute, or retain this message or any part of it. It may contain information which is confidential and/or covered by legal professional or other privilege (or other rules or laws with similar effect in jurisdictions outside England and Wales).
The views expressed in this email are not necessarily the views of Centrica plc, and the company, its directors, officers or employees make no representation or accept any liability for its accuracy or completeness unless expressly stated to the contrary.
A Centrica business British Gas Services Limited is authorised and regulated by the Financial Services Authority for its insurance mediation activities.
Registered office: Millstream, Maidenhead Road, Windsor, Berkshire SL4 5GD
Registered in England No 3141243.
Centrica plc
Registered office: Millstream, Maidenhead Road, Windsor, Berkshire SL4 5GD
Registered in England and Wales No 3033654
More information about the Synth-diy
mailing list