[sdiy] question about cables

[mailing gigaspeeds]

My question was for internal cabling, sorry about that.

For patch cabels i'm going with AS cables, I figure they don't sell crap 
:p  : http://www.analoguesystems.co.uk/buynow.htm

It's just that I have no cable at all for the inside and was wondering 
what you guys have in your workshop, colours etc...

Do you solder the internal cabling directly in the hole of a print ? I 
was thinking of soldering in one of those little pins so I can turn the 
wire around it and put some solder on it.
I had problems in the past with wire snapping of when you solder them 
directly in the hole...

thx a lot.

cheater cheater wrote:
> Why would you use a different cable inside the modular than you use
> outside the modular?
>
> Does the signal attain magical properties when it crosses the faceplate?
>
> Yes, the chassis shields the cable run inside from interference from
> the outside, but it doesn't shield it from interference from the
> inside, so what's the difference?
>
> On Sat, Aug 22, 2009 at 5:18 PM, Andre Majorel<aym-htnys at teaser.fr> wrote:
>   
>> On 2009-08-22 14:14 +0200, mailing gigaspeeds wrote:
>>     
>>> I want to order cables for my sdiy projects, could you guys give
>>> me some  advice about what I'll certainly be needing ?
>>>       
>> For what ? Patch cable or inside wiring ?
>>
>>     
>>> - diameter (conductor area)
>>>       
>> Not important. Short lengths, small currents.
>>
>>     
>>> - insulator colors (whas thinking black, white, red, yellow)
>>> - conductor material : copper, silver plated or tinned copper ?
>>>       
>> "Nude" copper slowly oxidises and becomes difficult to solder
>> after some years. Flux and/or fine sand paper help.
>>
>> For patch cables, you want to get as many colours as you can.
>> Gotham sell cable by the metre (DGS-1 and GAC-1 in four colours
>> and GAC-2 in eight colours).
>>
>>  http://www.gotham.ch/en/index.php?section=docsys&cmd=4_details&id=48
>>  http://www.gotham.ch/en/index.php?section=docsys&cmd=50_details&id=11
>>  http://www.gotham.ch/en/?section=docsys&cmd=23_details&id=6
>>
>>     
>>> Shouldn't I also take one single wire within the insulator
>>> instead of  all those fine/bundled ones ?
>>>       
>> Single-stranded wire is for installation. OK for inside wiring,
>> bad idea for patch cables.
>>
>> --
>> André Majorel <URL:http://www.teaser.fr/~amajorel/>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>>     
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>