Re: [sdiy] Schematics sdiy beginners question

[rdrake]

another great source for not only schematics but also full pcb layouts is Ray Wilson's "Music from Outerspace": http://www.musicfromouterspace.com/analogsynth.php?page=ANALOG

as for compatability: almost everyone uses a =/-5v point to point signal level as a standard, so almost all modulars are compatible on the signal level.  power is generally either 12 or 15 volt, tho many designs will work on either.  connectors: is SDIY, install whatever connectors work with your existing system!

b

>----- ------- Original Message ------- -----
>From: mailing at gigaspeeds.be
>To: synth-diy at dropmix.xs4all.nl
>Sent: Thu, 06 Aug 2009 11:44:54
>
>
>thx so far !
>
>I just found some designs on YUSYNTH's site as well
>:-) 
>http://yusynth.net/Modular/index_en.html
>now still have to figure out which designs are
>compatible (vco output 
>voltages and psu feed, connector type) with
>analogue systems/doepfer 
>modules :-)
>
>
>Derek Holzer wrote:
>> Two good places to check are the
>electro-music.com DIY forums, and 
>> also have a look at the CGS synthesizer modules.
>Ken Stone's PCBs are 
>> fantastic, if you choose to buy them.
>>
>> http://electro-music.com/forum/index.php?f=112
>> http://www.cgs.synth.net/modules/index.html
>>
>> Best!
>> Derek
>>
>> mailing gigaspeeds wrote:
>>
>>> I was wondering what you guys use in you're sdiy
>racks and if you 
>>> could point me to sources/schematics for :
>>>
>>> - CV/SIGNAL MIXERS
>>> - VCA (signal in, cv in lin & cv in log
>preferably)
>>> - VC ADSR
>>
>>
>
>_______________________________________________
>Synth-diy mailing list
>Synth-diy at dropmix.xs4all.nl
>http://dropmix.xs4all.nl/mailman/listinfo/synth-diy