[sdiy] rising cost of PCB's?

[Jerry Gray-Eskue]

Thanks for the info, I just ordered some of this paper.

I picked up a new Brother laser to do this with, and see that some people
are having problems using these. I did see and have used an Advanced print
option to Reduce Paper Curl OR Improve Toner Set - This seems to have
control over the Fuser Temperature and I am getting better results in the
Reduce Paper Curl mode.

Thanks Again

-----Original Message-----
From: David G. Dixon [mailto:dixon at interchange.ubc.ca]
Sent: Monday, April 27, 2009 11:08 AM
To: 'Jerry Gray-Eskue'; Synth-diy at dropmix.xs4all.nl
Subject: RE: [sdiy] rising cost of PCB's?


> I'm am starting to build boards using this method and have a quick
> question,
> What paper do you use?

Press-n-Peel Blue Transfer paper, with an old HP2100 Laserjet printer
(that's key -- the new laserjets run too hot, and the printing won't
transfer to the copper).  I must admit that I still hold my breath every
time I peel the backing off a new transfer...