[sdiy] Sorry, I CCed.

[Thomas Laskowski]

Haven't used the list in few years :S

I apologize.

-Tom

> From: hakerman at hotmail.com
> To: dingebre at 3dphysics.net; synth-diy at dropmix.xs4all.nl
> Subject: RE: [sdiy] Heat Sink Compound
> Date: Fri, 26 Sep 2008 16:49:07 -0400
> CC:
>
>
> If you don't mind spending a bit more, Digikey has a pretty good selection (if you're located in the US). I've got a big tube of some for around 20 bucks. I was replacing a power amp IC.
>
> -Tom
>
>> From: dingebre at 3dphysics.net
>> To: Synth-diy at dropmix.xs4all.nl
>> Date: Fri, 26 Sep 2008 13:27:34 -0600
>> CC:
>> Subject: [sdiy] Heat Sink Compound
>>
>> I am building several Blacet kits and in the VCO, the instructions say to
>> place the thermistor in contact with the matched transistor pair, ok all
>> good. But, is there any utility in adding some heat sink grease between the
>> thermistor and the transistor pair case? If so, is there a particular
>> type/brand of heat sink compound that is better to use?
>>
>> David
>>
>>
>> David M. Ingebretsen M.S., M.E.
>> Collision Forensics & Engineering, Inc.
>> 2469 East Fort Union Blvd. STE 114
>> Salt Lake City, UT 84121
>>
>> 801 733-5458 Office
>> 801 842-5451 Cell
>>
>> dingebre at CFandE.com
>> dingebre at 3dphysics.net
>>
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
> _________________________________________________________________
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

_________________________________________________________________