[sdiy] Panel Fabricating

[David Ingebretsen]

Introduced by PAiA, I think. 3U high, in multiples of 1.5 inches wide. Just
taller than Eurorack. Laurie Biddulph at Elby designs has a document which
goes into detail regarding the differences between FracRack and EuroRack.

It's at the bottom of this page:
http://www.elby-designs.com/panther/panther.htm

Blacet and PAiA are some of the more common sources for FracRack although
MetalBox, Cyndustries, Wiard, and Krisp are some who offer modules built or
as kits in FracRack format.

This link:

http://www.modularsynth.com/chart.html

compares some of the more popular module sources and the specifications.

David



-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Steffen Juul
Sent: Friday, September 12, 2008 5:41 AM
To: George Welsh
Cc: synth-diy at dropmix.xs4all.nl
Subject: Re: [sdiy] Panel Fabricating


On 12/09/2008, at 3.42, George Welsh wrote:

> Frac format

Pardon my ignorance, but what is that format? And what is it oppose  
to, DIN rack?
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy