[sdiy] Eagle

[Paul Maddox]

Guys,

 Thanks for the help, but none of these worked.
I select a group (even just half a dozen tracks) and click 'ripup' and
it deletes one track.

and I did have the board open at the same time as the schematic (it
does this by default), so I'm at a loss as to why the changes in the
schematic haven't been replicated in the board and why I can't rip up
the tracks.

 Even if I rip up the tracks the problem now is that the netlist on
the board doesn't match the netlist on the schematic, do I have to
re-export it or something?

Paul

On Sun, Sep 7, 2008 at 12:10 AM, ASSI <Stromeko at nexgo.de> wrote:
> On Sonntag 07 September 2008, Paul Maddox wrote:
>>  I'm trying to use Eagle LIt, I foudn a mistake on a board I autorouted.
>> So I updated the schematic, but now I need to rip up the old board,
>> update the netlist, and then re route it.
>
> Whenever you change something, you need to have both the board and the schematics open.  If you do this, they will keep in synch as far as this is possible.  If you edited the schematic without the board open I think an ERC should spot the differences, but you need to manually correct them.  If the differences are slight (pinswap or something like this) it is usually better to just rip a few traces and re-route incrementally.
>
>> I can only figure out how to ripup a single track, not the board, and
>> updating the netlist doesn't seem do-able, is it?
>
> Execute "ripup *" in the command line or click ripup, then the green traffic light symbol.
>
>
>
> Achim.
> --
> +<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk]>+
>
> Factory and User Sound Singles for Waldorf Blofeld:
> http://Synth.Stromeko.net/Downloads.html#WaldorfSounds
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>