[sdiy] Eagle

[ASSI]

On Sonntag 07 September 2008, Paul Maddox wrote:
>  I'm trying to use Eagle LIt, I foudn a mistake on a board I autorouted.
> So I updated the schematic, but now I need to rip up the old board,
> update the netlist, and then re route it.

Whenever you change something, you need to have both the board and the schematics open.  If you do this, they will keep in synch as far as this is possible.  If you edited the schematic without the board open I think an ERC should spot the differences, but you need to manually correct them.  If the differences are slight (pinswap or something like this) it is usually better to just rip a few traces and re-route incrementally.
 
> I can only figure out how to ripup a single track, not the board, and
> updating the netlist doesn't seem do-able, is it?

Execute "ripup *" in the command line or click ripup, then the green traffic light symbol.



Achim.
-- 
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk]>+

Factory and User Sound Singles for Waldorf Blofeld:
http://Synth.Stromeko.net/Downloads.html#WaldorfSounds