[sdiy] neophyte question - 9 volt battery to CV control

[Dump Static]

Also try using a photo-resistor instead of the pot.  Then the amount of light controls the voltage.

That was my first DIY project (thanks for the encouragement bbob!)

Drew


>>> ahlist <ahlist at gmail.com> 09/03/08 11:35 PM >>>
Hi,

I'm new to all this. In my inexperience, I envision something like the
following:

a 9 volt battery attached to some resistors(?) to take down the
voltage attached to a potentiometer attached to a CV input.

Would something like this work?

The end goal would be to use similar analog outputs from a
micro-controller to the CV input.

All advice and education appreciated.
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy