Metal sources WAS (RE: [AH] RE: [sdiy] Re: [AH] Making holes in Aluminum?)

[flightofharmony]

Sorry about that everyone!

On that note (for you Frac format folks), many hardware shops that have the
racks of metal rod/sheet/tube/flat/plate often have flats of anodized
aluminum in 1.5" and 3" widths (and usually in either 1/16" or 1/8"
thickness) - all you have to do is cut to length.

~flight
flight at flightofharmony.com
http://www.flightofharmony.com


-> -----Original Message-----
-> From: flightofharmony [mailto:flight at flightofharmony.com]
-> Sent: Monday, October 27, 2008 11:42 AM
-> To: analogue at hyperreal.org; synth-diy at dropmix.xs4all.nl
-> Subject: RE: [AH] RE: [sdiy] Re: [AH] Making holes in Aluminum?
-> 
-> 
-> 
-> ~flight
-> flight at flightofharmony.com
-> http://www.flightofharmony.com
-> 
-> 
-> -> -----Original Message-----
-> -> From: david l [mailto:greyplaid at gmail.com]
-> -> Sent: Monday, October 27, 2008 11:30 AM
-> -> To: analogue at hyperreal.org
-> -> Subject: Re: [AH] RE: [sdiy] Re: [AH] Making holes in Aluminum?
-> ->
-> -> Thanks for the reply! For anybody who cares, my local Home Depot sells
-> 5inch
-> -> X 8inch aluminum (I think) "metal shingles" in their roofing section
for
-> 59
-> -> cents a piece. I grabbed a few for my modular project..
-> ->
-> -> -David