[sdiy] tinning home etched boards?

[Samppa Tolvanen]

On Sat, Oct 18, 2008 at 10:27 PM, David G. Dixon
<dixon at interchange.ubc.ca> wrote:
> Dan,
>
> I apologize if this is a stupid question, but do your printed pads have
> holes in their centers?  If you are printing solid pads, then there is
> nothing to guide the drill bit.  If you print little circles for pads, with
> the hole about the same size as your drill bit, then you almost can't go
> wrong.
>

I use a much smaller marks for drillholes than the actual bit is.. You
get the drift.

Samppa