[sdiy] Desperately seeking knobs for 6mm D-shaft, no pointer

[Sam Ecoff]

Hi Adam...

I recently discovered that so long as the set screw hits the round  
side of the shaft, you can use knobs designed for round shafts with a  
D shaped shaft with no problems. Given that you are not intending to  
use a knob with a position indicator, this should be a piece of cake  
for you.

HTH

Sam E.


On Oct 18, 2008, at 10:46 AM, Adam Schabtach wrote:

> I'm trying to find knobs with the following specifications:
>
> -Diameter less than 2cm
> -Fits on 6mm D-shaped shaft with 4.5mm flatted section
> -No position indicator--no dot, no pointer, no line, etc.
> -Available in quantities of 100 or fewer in the U.S. (I really need  
> only 66
> but would purchase 100 if I had to)
> -Preferably not terribly expensive (although I'm gettting desperate)