[sdiy] accutronics reverb for modular

[Brett Maddaford]

Hi Guys

 

I have a accutronics reverb here that I am wanting to use as a stand alone
reverb. I believe it to be an accutronics but can't find a mark but I think
it is.

The unit came from a Hammond organ, either a 126JM3 or 123J3 and it has the
amp pcb attached. It has a six pin connector running 5 wires to the reverb
(one soldered to the body of the reverb unit) and a pair going to either end
of the spring....obviously the in\out.

 

It has 9 pins on the pcb as well which is obviously to connect to the
original organ etc I was someone  might have something with the pinouts etc
and might know if its expecting a line level signal etc?

 

The only possible markings I can see on the amp are RA-1C and 223-36213A and
a stamp of 121 under the reverb amp marking.

 
Anyone know much about these?

 

Cheers

Brett


**********************************************************************
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this email in error
please delete the e-mail & notify the system manager.
We reserve the right to scan all e-mail traffic for restricted content
and to monitor all e-mail traffic in general.
The views and opinions expressed in this e-mail are those of the sender 
and do not necessarily reflect the views of the organisation
by whom they are employed, except where the sender expressly
and with authority states them to be so.
This footnote also confirms that this email message
has been checked for the presence of computer viruses and script.
We believe but do not warrant that this e-mail is free from viruses.
Responsibility for virus checking rests entirely with the recipient.
5 at 356
**********************************************************************