[sdiy] Roland SH5 schematics and slider?

[Travis Thatcher]

I've gotten several CEM chips from CHIPSFORBRAINS and just ordered a
pitch bender for my sh101 off him.  He's pretty fast on shipping, and
everything has arrived as advertised.  He usually has a lot of stuff.

-travis

On Wed, May 14, 2008 at 10:06 AM, GRAHAM ATKINS
<gatkins at blueyonder.co.uk> wrote:
> Hi Daniel,
>
> There is a seller who uses both EBAY.COM and EBAY.CO.UK called
> CHIPSFORBRAINS. He has
> had a lot of Roland parts "Re-made" in the far east, he does rotary and
> linear pots, control knobs, switches,
> IC's and other bits, often as kits for certain Roland models. I'm pretty
> sure he did some Roland System
> 100 (Not 100M) parts recently from about the same time as the SH5. Keep
> looking out, he seems to put
> several lots up then goes away for a month or so. Worth a look.
>
> Graham
>
> On May 14, 2008, at 13:15, Daniel Araya wrote:
>
>> Hi,
>>
>> I have a battered old SH5 on the operating table and the schematic I found
>> online miss a few pages (PSU, tuning and adjustment instructions) and has
>> generally bad image quality on the schematics.
>> Does anybody have a better scanned copy?
>>
>> The slider for S/H-rate is badly corroded, are there any sources for
>> spares? Its a 500k A slider with about 35mm stroke.
>>
>> Regards
>>
>> /Daniel
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>



-- 
http://www.judichicago.com
http://www.myspace.com/judichicago
http://www.recompas.com
http://voiceofsaturn.blogspot.com