[sdiy] Press-N-Peel Bluee and color laser printerS?

[Ben Lincoln]

On Tue, May 6, 2008 12:30 pm, Samppa Tolvanen said:

> Simply hand positioning. Once learned how PCB vs. drill bit should
> *look like* from the angle and inspection lenght my eyes are when
> actually doing the drilling, positioning becomes pretty automated yet
> accurate enough, so I don't spend much time per hole. I use toner
> transfer and leave "drill hole" size inside the pad to 0,3mm which
> seems to guide drill bit too.

Ah, OK, thanks.

I might be overly paranoid because I tried hand-positioning something
without clamping in my drill press awhile ago and it spun around and was
smashed apart due to the higher torque compared to a handheld tool. I
haven't had a chance to try it again with a lower torque setting.