[sdiy] Male connectors for Analogue Systems on a Doepfer bus?

[synth junk]

Although that works the wirewrap pins are much thicker than typical
header pins and will weaken the sockets. I can't believe that they're
using those connectors to begin with as they are quite flimsy.


>  I remember reading in the Synergy repair guide that one or more of the
>  boards used wire-wrap IC sockets as improvised male DIP connectors, so
>  you could always do that too in a pinch. Assuming I'm correct and they
>  are DIP connectors.
>
>
>  Joachim wrote:
>  > does anyone know where I can get those male connectors which
>  > Analogue Systems uses for their power cables?
>  >
>  > I want make my own conversion cables like the ones you see
>  > on the following pictures:
>  > http://www.bigcitymusic.com/i/cat/New/1000415_L.jpg
>  >
>  > http://www.bigcitymusic.com/i/cat/New/1000288_L.jpg
>
> _______________________________________________
>  Synth-diy mailing list
>  Synth-diy at dropmix.xs4all.nl
>  http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>