[sdiy] Modulating a square wave

[Veronica Merryfield]

Switching between two references is probably the simplest way forward.  
You could use a CMOS switch or a couple of FETs in push-pull if you  
can fets with gate specs to suit and possibly always having the mark  
 >= space level which from what you say would be the case.

On 10-Mar-08, at 1:34 PM, Justin Owen wrote:

> Hey all,
>
> I could do with some advice on a particular way of modulating a  
> square-wave.
>
> A 'standard' square-wave goes up and down between, say, 5 volts  
> (mark) to 0 volts (space). I'd like a square-wave where I had  
> independent control over the voltages/amplitude of (ideally) both  
> the 'mark' and 'space' - so I could have, say, a square-wave that  
> was made up of between 5 volts (mark) and 2 volts (space) or 4 Volts  
> and 1 Volt or 1 Volt and 5 volts - or any other combo.
>
> So instead of adjusting the width - you're adjusting it's 'height'.
>
> At this stage it would be for control voltage purposes (e.g. to  
> control the output of a VCA) - so the frequency wouldn't have to be  
> super-fast/high. I'd also be happy with having control over just the  
> 'space' (i.e the part of the square-wave that is normally at 0  
> Volts) and in a pinch I'd accept 'stepped' control rather than  
> linear if that was going to be much easier.
>
> I figured I could use a 'normal' square-wave to switch between two  
> different 'reference' voltages (via a CMOS switch or a Multiplexer?)  
> or I could use a comparator and drop the High Voltage and boost the  
> Low one - but I was hoping there might be a simpler/more established  
> way.
>
> (oh - I posted this earlier today in Rich text - so it didn't go  
> through - apologies if this turns up twice)
>
> Many thanks,
>
> Justin
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy