[sdiy] Aaron's first PCB layout

[Aaron Lanterman]

On Jun 7, 2008, at 5:43 AM, Csaba Zvekan wrote:

> Hi Aaron,
>
> I would Isolate a little bigger for your ground plane. Cause you  
> might have problems etching and soldering that thing later. (unless  
> you give it to PCB manufacturing place, then it's OK).Also check  
> your clearance in NetClasses and DesignRules  .It looks to me that  
> under the ground plane above the (2.2R?) resistor (what is 2.2R  
> anyway , did you mean 2.2K?) lays a hidden trace that Eagle finds to  
> close to you next trace according to your DRU(DesignRules) settings.

I thought the 2.2R is weird too. I think it's meant as a cheap fuse.

This is based on a redrawn schematic of a Buchla 294, which I think  
itself was created by reverse engineering a 294.

- Aaron