[sdiy] what is the hole size for 9mm pots??? Bourns 3310C-101-104

[Dan Snazelle]

i am embarassed to say I HAD the datasheet opened.  i just could not figure out how to read the mechanical drawings well enough to understand WHICH number was for the hole size and which was for the shaft.

BTW- i still cant seem to find a good pot in my price range that has a 1/4" shaft.

any ideas?

--------------------------------------------
check out various dan music at:

http://www.myspace.com/lossnyc


http://www.soundclick.com/lossnyc.htm


http://www.indie911.com/dan-snazelle
(or for techno) http://www.myspace.com/snazelle


> Date: Tue, 29 Jul 2008 07:11:59 -0500
> From: xpandrew at ph.k12.in.us
> To: subjectivity at hotmail.com
> CC: synth-diy at dropmix.xs4all.nl
> Subject: Re: [sdiy] what is the hole size for 9mm pots??? Bourns 3310C-101-104
>
> Look for a data sheet file. Mouser usually has a link to them.
>
> Drew
>
>>>> Dan Snazelle  07/28/08 6:44 PM>>>
>
>
>
> i need to know really quickly what the size would be for these nice bourns pots...they arent too bad a price at 25 pieces.
>
> some nice person on here (cant remember who) had said he swares by these..so i guess i will go with these and serge knobs!!
>
> just need to know the panel (drill size) hole.
>
> 3/8"??
>
> thanks
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>