SV: Re: [sdiy] Error on the SoundBite board!

[karl dalen]

The best thing you can do are to invest in a decent hot air pencil,
those who are sawey can build their own. All the hassles with
soldering and desoldering gets reduced significantly.

REg
KD

> The trick to unsoldering SMDs is to glob a ton of solder on them, then it
> falls right off. Then use the desolder braid to clean up.  Glob enough solder
> so it bridges both sides of the 0805.  Easy.
> 
> -troy
> 
> On Sun, Feb 03, 2008 at 02:33:19PM -0700, Adam Schabtach wrote:
> > > Took me about 3min to swap out, now it works perfectly.
> > 
> > Do you have a good trick for unsoldering 0805s? Or do you have rework
> tools?
> > Just curious; undsoldering SMT packages turns out to be a lot trickier than
> > soldering them, in my experience.
> > 
> > --Adam
> > 
> > 
> > _______________________________________________
> > Synth-diy mailing list
> > Synth-diy at dropmix.xs4all.nl
> > http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> 
> -- 
>
------------------------------------------------------------------------------
> tsheets at saturn5.com                                  <- You have found me   
> http://www.ferrapsylix.com                           <- sub atomic breakbeat
> "I just don't have the discipline to be a hippie"    <- Homer J. Simpson
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> 



      __________________________________________________________
Låna pengar utan säkerhet. Jämför vilkor online hos Yahoo!
http://shopping.yahoo.se/c-100390123-lan-utan-sakerhet.html?partnerId=96915014