[sdiy] Conductive rubber for ribbon controller

[Paul Perry]

The conductive rubber mats I have experimented with, had nowhere near a low
enough resistance. But maybe these are OK!
Note that with a sheet of conductive material, you can apply voltages at
various points and tap off a 'mix' at points anywhere on the surface.

Paul perry Melbourne Australia

-----Original Message-----
On Behalf Of Andre Majorel
http://vermason.co.uk/FullCatalog/BenchwareandFieldService/WorksurfaceMats/C
onductiveNeopreneRubberMatting/

The resistance seems to be in the right range (1~100 k) and the
material should be durable. There might be some friction, though.