[sdiy] Should I use REAL PCBS or ETCHED

[Dan Snazelle]

i googled

Vector T42-A
and searched MOUSER

nothing came up.

searching in the wrong places??

thanks








--------------------------------------------
check out various dan music at:

http://www.myspace.com/lossnyc


http://www.soundclick.com/lossnyc.htm


http://www.indie911.com/dan-snazelle
(or for techno) http://www.myspace.com/snazelle


> From: harrybissell at wowway.com
> To: subjectivity at hotmail.com; pfperry at melbpc.org.au; synth-diy at dropmix.xs4all.nl
> Subject: RE: [sdiy] Should I use REAL PCBS or ETCHED
> Date: Thu, 14 Aug 2008 11:44:51 -0500
>
> On Thu, 14 Aug 2008 15:56:52 +0000, Dan Snazelle wrote
>
>> harry-you mean you sell products that have vectorboard inside as the
>> main boards?
>
> Mostly they are units I built for myself... still working since
> College (mid 70's).
>
>>
>> does perfboard present a nightmare situation though if THIS EVER
>> NEEDS REPAIRS?? if i did etch or pcb house and a board went bad, i
>> could just pull out the PNP template and make another. if i used
>> perf, well it sounds like it would be hard. plus, doesnt vector or
>> perfboard not hold up as well when soldering and resoldering (as in
>> the case of replacing faulty parts,etc)
>
> Check out what the Vector T42-A terminal is. These are pushed into
> the holes in the vectorboard. You wire to the bottom (usually) and
> the components are on the top side... you can resolder hundreds of times
> (on the component side) if you need to. I use the fiberglass perfboard
> (not paper phenolic). Its tough stuff.
>
> H^) harry
>
>>
>> thanks so much
>>
>> --------------------------------------------
>> check out various dan music at:
>>
>> http://www.myspace.com/lossnyc
>>
>> http://www.soundclick.com/lossnyc.htm
>>
>> http://www.indie911.com/dan-snazelle
>> (or for techno) http://www.myspace.com/snazelle
>>
>>> From: pfperry at melbpc.org.au
>>> To: synth-diy at dropmix.xs4all.nl
>>> Date: Fri, 15 Aug 2008 01:20:29 +1000
>>> Subject: [sdiy] Should I use REAL PCBS or ETCHED
>>>
>>>
>>> The answer varies for different people.
>>> Personally, I find stripboard (aka veroboard) by far the best for me.
>>> I notice that people who are significantly more intelligent than I, usually
>>> prefer pad per hole board.
>>>
>>> paul perry Melbourne Australia
>>>
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
> Harry Bissell & Nora Abdullah 4eva
>