[sdiy] QTC and delurk

[Veronica Merryfield]

Hi Neil

I have experience with TDR in a couple of application areas. One thing that
it could do is pickup playing harmonics as well as 'fretting' the string.
However, TDR is complex at the best of times and comparatively short
transmission times make it harder. It is on the bottom of the list.

Yes it is a complex problem with no simple solution. Whilst using QTC does
have issues, it does have the dangling carrot of sensing position and after
touch..

Thanks

Veronica

----- Original Message ----- 
From: neil.johnson97 at ntlworld.com
To: Veronica Merryfield
Cc: synth-diy at dropmix.xs4all.nl
Sent: Monday, May 14, 2007 3:10 AM
Subject: Re: Re: [sdiy] QTC and delurk



> > However, a system that has some form of hint scheme that can
> > steer a pitch detector holds much hope - it's very much like giving a 
> > PLL
> an
> > input frequency that is close to where it needs to lock.

If the strings are metallic then perhaps some kind of time domain
reflectometry (TDR) system to measure the length of the vibrating string
might provide an accurate input?  In this case the fret board would simply
be a conductive medium to provide an impedance discontinuity at the point
the finger is applying pressure to the string.  Note that this technique is
not easy, but it does make the (electrical) design of the fret board easier.

I get the impression that any solution for this problem is going to be
complex, the question boils down to where you want the complexity, and where
you don't want it.

Neil

-----------------------------------------
Email sent from www.virginmedia.com/email
Virus-checked using McAfee(R) Software and scanned for spam

_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy