[sdiy] Alternatives to Faders

[John Luciani]

On 3/7/07, Edward King <edwardcking2001 at yahoo.co.uk> wrote:
> > I don't know of any, but I recently looked into buying 10mm acrylic sheet
> > with a view to cutting circles out of it for exactly this purpose. I was
> > only going to need two, so thought to do it by hand, but if you needed
> > lots, you could probably get someone to machine them for you.
> >
>
> This is probably a good idea. I have actually found some wheels. But the
> difficulty is getting ones with the grooves cut into them. Im not sure how
> you would machine these grooves into acrylic?

If you can tolerate an opaque finish you can use a wood router to machine
your grooves.

(* jcl *)

-- 
http://www.luciani.org