[sdiy] Frac dimensions?

[dj hohum]

And the answer is: 4 1/4 inches. That's assuming my pocket tape rule
can be trusted. I should point out, however, that even paia's kits
expect you to tuck bits under the lips to get almost an additional 1/4
inch top and bottom. But a vertical card that must fit has to be less
than 4 1/4 inches.



On 6/22/07, Tim Parkhurst <tim.parkhurst at gmail.com> wrote:
> Hi All,
>
> I'm fiddling with a layout for a Frac panel, but I don't currently own
> a Frac Rack. Can someone tell me the open distance between the panel
> mounting rails? In other words, I'm looking for the "safe area" where
> components can mount on a panel. Thanks to the drawing on the Blacet
> site, I know the overall size and where the mounting holes are, so I'm
> just looking to verify the opening between the rails. In inches or
> millimeters is okay, but please be accurate (I'm looking for something
> like "4.35 inches" and not "a little over 4 inches.")
> :-)
>
> Tim (yes I know I need to buy one, but I'm impatient) Servo
> --
> "Imagination is more important than knowledge." - Albert Einstein
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>