[sdiy] Moog Rogue foam gunk

[Oakley Sound]

 > What is the recommended way of cleaning this?

If its a small amount I tend to go at it with cotton wool buds and 
iso-propyl alcohol. I then use small bits of paper towels to mop up the 
now slightly more liquid tar. Its a long process.

For large contaminations I remove all the pots, Temp cos, trimmers and 
switches. I then clean as much as I can with the above method, and then 
immerse the whole board in hot soapy water and give it a good scrub. 
After thoroughly drying, and yet more cleaning with IPA, it may be then 
good enough to put back the sliders and other hardware.

Chipforbrains on Ebay sells the slider replacements which seem good 
enough for the job. I can normally clean the switches to use again.

The trimmers can usually be cleaned, but if not new ones can be 
purchased from the normal suppliers.

Don't forget to clean under the front panel, and also around the 
cut-outs of the sliders and switches.

Tony

www.oakleysound.com/projects.htm <- Oakley Modular
www.oakleysound.com/music.htm    <- Electronic Music by Takla Makan