[sdiy] ..and so it goes on (more OSCar issues)

[Julian]

>>Removing the analogue / midi board from the control board always results 
>>in
>>the machine needing to be switched off and on a number of times before 
>>itll
>>boot properly.

>Pardon me if I misinterpreted you, but your message implies that you are 
>removing the analogue / midi board while the power is on. This is a very 
>bad practice. Always power off the device in question >before removing any 
>component, PCB, etc.

No.

If the board has been disconnected from the control board when the machine 
is OFF, when it is all connected again, and the machine turned back ON then 
it needs to be power cycled a few times before itll boot correctly.

I assume this is due to the battery backup being located on the control 
board, and the processor board being temorarily disconnected from this.

Julian