[sdiy] stripper recommendations

[Altitude]

We use these for FO applications but they are also made for small wire sizes
and are wonderful.

http://www.claussco.com/nnfiber.htm

Techni-tool carries the wire ga sizes

-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Ian Fritz
Sent: Sunday, December 02, 2007 9:02 PM
To: Tim Parkhurst; Paul Schreiber
Cc: synth-diy at dropmix.xs4all.nl
Subject: Re: [sdiy] stripper recommendations

At 06:16 PM 12/2/2007, Tim Parkhurst wrote:
>And if you're not doing wire wrap, why are you using 30 gauge wire?

I use it for perfboard wiring.  Solder all components into pad-per-hole 
boards with a bit of the leads sticking through.  Wire between these 
"posts" with 30 gauge wire.

   Ian 

_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

__________ NOD32 2697 (20071202) Information __________

This message was checked by NOD32 antivirus system.
http://www.eset.com