[sdiy] Cutting PCBs

[tsheets at saturn5.com]

I am finally getting around to building my AVR-X synth (www.avrx.se), but
the PCB they sent me that needs to be broken into two has no break-away tabs
or anything on it.  I need to saw this thing in half but I have very little
margin of error.  Any suggestions?  A jigsaw (skillsaw) seems too rough.
A hack saw does not seem very accurate.  I do have a dremmel, but that seems
like it could take forever.

I wanted to discuss this on the AVR-X forum, but I have not gotten accepted
yet.  I think everyone is Europe is on holiday right now.. :)

-troy


------------------------------------------------------------------------------
tsheets at saturn5.com                                  <- You have found me   
http://www.ferrapsylix.com                           <- sub atomic breakbeat
"I just don't have the discipline to be a hippie"    <- Homer J. Simpson