[sdiy] MOTM300 is an interesting design

[Aaron Lanterman]

As a side note - Paul's VCO is a sawtooth core, but the integrator isn't 
quite like anything I've seen. There is no integrating op amp. The cap 
just sort of hangs out, and is buffered by this dual-FET uberbuffer 
between it and the relatively low-impedance input LM319 (it reminds me of 
some early Buchla stuff where he puts FETs before BJT op amps).

And the intergrating cap it discharged with... a 2N4402 BJT???? Not a FET 
or MOSFET? Strange and interesting...

The summer stage looks top notch... all OP275s and such...

- Aaron

-----------------------------------------------------------------------------

Dr. Aaron Lanterman, Asst. Prof.
and Demetrius T. Paris Junior Prof.    Voice:  404-385-2548
School of Electrical and Comp. Eng.    Fax:    404-894-8363
Georgia Institute of Technology        E-mail: lanterma at ece.gatech.edu
Mail Code 0250                         Web:    users.ece.gatech.edu/~lanterma
Atlanta, GA 30332                      Office: Centergy 5212