[sdiy] PCB fab using Pulsar TTS

[Tim Parkhurst]

On 8/21/06, jerry laxton <jeridanger at yahoo.com> wrote:
>
> Hi
> Forget about the Pulsar products and go down to the local Staples
> office supply store and buy a package of cheap photo paper
> (the glossy stuff), use the same process with the iron etc.
> You can have really good results with this stuff.
> Actually  lots of the photo papers will work for toner transfer.
> I could never get the Pulsar stuff to work very good.
> Jeri
>

Hi Jeri,

This sounds like a really good idea. I think I had heard that
somewhere, but I wasn't able to confirm. I have a question though:
What type of printer and paper have you tried? Basically, I was
wondering if you used ink-jet photo paper and a laser printer, or
laser photo paper and a laser printer? Also, I'm assuming a monochrome
laser, but I have access to a color laser at work so I'm wondering if
that would give significantly better (or worse) results.

Tim (or worse) Servo

-- 
"Imagination is more important than knowledge." - Albert Einstein