[sdiy] FS: lots of DIY stuff

[allenre at umich.edu]

I have a bunch of DIY stuff I need to clear out because I just need to clear up
some room:

1 TR-9090 board set, nearly complete.
1 TB-3030 board, nearly complete

2 unpopulated sets of Milton sequencer boards.

1 custom TR-808 clone board (my design).  Has all the sounds, minus a tom and a
cowbell, I think.  component values are missing from the board, but I will give
you the PCB layout files so you can complete it if you want.

midwest analog power supply (+/- 15V)

2 additional pcbs for power supplies, and parts needed to build them (intended
to be 5V and 12V bipolar

drilled panel for power supplies

drilled panels to accomodate the TR-9090 and 808 clone

drilled panel that was meant to accomodate an unbuilt modular.  i can tell you
what modules I was planning on putting into it, if you are interested in
building it.

lots and lots of extra parts: resistors, caps, knobs, 1/4" jacks, transistors,
opamps, 2k tempco resistors, stranded and solid core wire of various gauges,
mic cable and 1/4" plugs, power tranformers

Only a few more components need to be added to the 9090 and 3030 boards (I
missed ordering a few inexpensive parts)

there is probably stuff that I forgot to mention, but this covers most of it. 
The TR-9090 board, TB-3030 board (with rare parts kit), 2 Milton sets and
midwest analog products would top $500.

I am asking $500 for everything, or $600 if you also want my heavy duty
Milwaukee corded drill (I think it is 8 Amps, but I can check) with cobalt bit
set, deburring bit set and a couple sets of files.  I can ship it, but would
prefer not to.  I am located in Ann Arbor.  Email me if you are interested.