[sdiy] wondering how to a pcb behind a pannel neatly?

[Travis Shire]

JB Weld maybe? I'm sure I'd hold for a while...its tough stuff......


> If you make angle bracket type legs...or "L" shaped legs that is...you
> can use goop adhesive on them also.  The stuff never comes off unless
> you want it to that I've seen on that type of application.  Goop
> automotive adhesive or it's variants.-Bob
>
> Tom Arnold wrote:
>
> >On Sat, Oct 22, 2005 at 05:47:52AM +0100, Julian wrote:
> >
> >
> >>   What im wondering is how threaded spacers can be attached to the rear
> >>   of the panel?  Then I could just bolt the pcb to these.
> >>
> >>
> >
> >You could solder them there ( really...  look for Aluminum
fluxes/solders...
> >use plenty of ventilation etc etc ).
> >
> >Another possibility are they make studs that will press fit into a hole.
I
> >forget what they're called but when they are press fit they mushroom in
the
> >bottom of the hole so they wont fall out.
> >
> >
> >