[sdiy] wondering how to a pcb behind a pannel neatly?

[Bob Weigel]

If you make angle bracket type legs...or "L" shaped legs that is...you 
can use goop adhesive on them also.  The stuff never comes off unless 
you want it to that I've seen on that type of application.  Goop 
automotive adhesive or it's variants.-Bob

Tom Arnold wrote:

>On Sat, Oct 22, 2005 at 05:47:52AM +0100, Julian wrote:
>  
>
>>   What im wondering is how threaded spacers can be attached to the rear
>>   of the panel?  Then I could just bolt the pcb to these.
>>    
>>
>
>You could solder them there ( really...  look for Aluminum fluxes/solders...
>use plenty of ventilation etc etc ).
>
>Another possibility are they make studs that will press fit into a hole.  I
>forget what they're called but when they are press fit they mushroom in the
>bottom of the hole so they wont fall out.
>
>  
>