[sdiy] 4066 datasheet question

[john mahoney]

> So basically the voltage that can be applied to the 4 switches is the supply voltage + " a small saftey margin".

Yes. Of course, you should design for the "Recommended Operating Conditions":
    Supply Voltage (VDD) 3V to 15V
    Input Voltage (VIN) 0V to VDD
--
john

  ----- Original Message ----- 
  From: mikael at mikmo.dk 
  To: synth-diy at dropmix.xs4all.nl 
  Sent: Saturday, October 01, 2005 3:17 PM
  Subject: [sdiy] 4066 datasheet question



  As the electronics newbee i am, i'm trying to understand the 4066 datasheet.

  Is it correct if i think that the voltage that can be switched on / off with the 4 switches depends on the supply voltage to the 4066, and is almost equal to it. So if i supply the 4066 from a 9 volt source (vdd) i can switch up to 9.5 volts (if vss is 0).

  So basically the voltage that can be applied to the 4 switches is the supply voltage + " a small saftey margin".

  Thanks

  Mikael






  =
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20051003/f18ab6bb/attachment.htm>