[sdiy] Chip Tempcos was RE: Solder paste and toaster ovens

[Peter Grenader]

Harry Bissell Jr wrote:

> If I had to use the chip tempco, I'd epoxy it to the
> bottom of the can, then solder teeny-tiny flying leads
> to it (maybe 28ga) so that the leads don't transfer
> heat FROM the board.


Yes - I've considered this. but doing it multiple times I would probably
also consider suicide by the time I was done.  The issue with transferring
heat from the board doesn't concern me, it's something I would actually
prefer. As long as it's transferring the same amount of heat to the chip AND
to the tranny, I'm good., Using the board as a heat source (or sink?)  would
probably help to stabilize the temperature delta between the two parts,
which is the best solution I could ever ask for.