[sdiy] Mounting hole size/location for FracRack panels

[Jay Schwichtenberg]

Now that I'm home...

Hole size seems to be ~.135". Hole spacing for single is 0.75" in from the
edges, dual 0.75" in from the edges 1.5" apart. I tapped out the chassis
holes and use black 4-40 thumb screws from Small Parts.

Again if you are drilling your own panels start from the center and work
out, don't use the edges.

Jay S.
  -----Original Message-----
  From: owner-synth-diy at dropmix.xs4all.nl
[mailto:owner-synth-diy at dropmix.xs4all.nl]On Behalf Of Jonathan Lutz
  Sent: Tuesday, June 14, 2005 12:59 PM
  To: synth-diy at dropmix.xs4all.nl
  Subject: [sdiy] Mounting hole size/location for FracRack panels


  I am in the midst of designing a few FracRack-sized panels and am
wondering if there is some sort of spec for size and location of mounting
holes?  I fear that if I try to 'measure and guess', I will potentially
screw it up and waste a bunch of money on panel fab.  (Better to ask those
who have designed these before!)

  It would be ideal to know the size/location for both single-width and
double-width panels.

  Thanks again!
  JON

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20050615/71ce193f/attachment.htm>