[sdiy] Mounting hole size/location for FracRack panels

[Jonathan Lutz]

YES! Thanks everybody for all the information.. this makes my life so much 
easier.

JON

On 6/14/05, jays at aracnet.com <jays at aracnet.com> wrote:
> 
> Jon,
> 
> If you are using real PAIA FracRac panels use the mounting hole as your 
> reference points and not the edges. The panels edges are not exact so using 
> those as reference points can give you cock-eyed panels. Using the mounting 
> holes as reference will give you a centered panel.
> 
> May you drill bits always be sharp.
> Jay S.
> 
> Jonathan Lutz wrote:
> 
> > I am in the midst of designing a few FracRack-sized panels and am 
> wondering=
> > =20
> > if there is some sort of spec for size and location of mounting holes? 
> I=20
> > fear that if I try to 'measure and guess', I will potentially screw it 
> up=
> > =20
> > and waste a bunch of money on panel fab. (Better to ask those who 
> have=20
> > designed these before!)
> >
> > It would be ideal to know the size/location for both single-width and=20
> > double-width panels.=20
> >
> > Thanks again!
> > JON
> 
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20050614/671c477a/attachment.htm>