[sdiy] SMD prototyping technique?

[phillip m gallo]

John,

Yes, SMD adhesive is typically an epoxy and sparingly used. It's easier, to
connect direct to the chip leads, if you carefully elevate alternate device
pins.  I prefer to use commonly available adapters which can be found for
the "heavy traffic" device pin outs.   The board shown is "Surfboard" for 16
pin SOIC.

http://www.geocities.com/gallomagnetix/Vca1.jpg

regards,
p


-----Original Message-----
From: owner-synth-diy at dropmix.xs4all.nl
[mailto:owner-synth-diy at dropmix.xs4all.nl]On Behalf Of john mahoney
Sent: Saturday, June 04, 2005 8:27 PM
To: synth-diy at dropmix.xs4all.nl
Subject: [sdiy] SMD prototyping technique?


Wouldn't it be possible to stick SMDs to perfboard with a epoxy, and then
solder leads (as in "wires" ;-) to them?
--
john



--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.6.2 - Release Date: 6/4/05