[sdiy] Blank 'MOTM' panels

[David Brown]

I made my cabinets and used 1/4" stained and varnished birch ply for 
the rear .  At the time I only filled up half the cabinet and 
wondered what I was going to fill in the empty spaces with.  I just 
used a left-over piece of birch ply.  I just drilled two holes in 
each end.  Every time I filled in a module, I'd just take the cover 
and cut 1-3/4" off of it and drilled two new holes.  Worked 
great.  Finally only had 4U of panel left and just recently used this 
for a VFD display.

They 'skim' on the thickness so it wasn't quite 1/4" and only stuck 
out a little from the other panels.  I have also glued black paper to 
left over panels.  My empty spaces don't seem to last very long. I 
have only one remaining photo of a wood panel on my site - third 
photo from the bottom.

http://modularsynthesis.com/cabinet/cabinet.htm

Dave

 > Jeff Farr wrote:
 >
 > Does anyone sell MOTM style panels in various widths?  Is there an
 > easy way to make these without knowing my way around metalwork?