[sdiy] Anyone sucessfully built an EFM Vco4d?

[Jay Schwichtenberg]

Julian,

Yes it works but there are some changes on the PCB that you need to make and
you need to leave out R17 and R18. These are documented in the card docs.
Also put a 4.7K on the output of the pulse comparator (U5 Pin 1) to ground.
It needs a pull up to get a solid signal out for pulse.

Jay S.

> -----Original Message-----
> From: owner-synth-diy at dropmix.xs4all.nl
> [mailto:owner-synth-diy at dropmix.xs4all.nl]On Behalf Of Julian
> Sent: Tuesday, January 25, 2005 3:15 AM
> To: Synth DIY
> Subject: [sdiy] Anyone sucessfully built an EFM Vco4d?
>
>
> You do anythng special to it to get it to work?
>
> Just trying to work out if its my mistake or not.
>
> Cheers, Julian
>