[sdiy] dual VCFs

[James Patchell]

If you want something to perhaps start with, you might give my Vocal Filter 
a try.

http://www.oldcrows.net/~patchell/synthmodules/vocalfilter.html

I still have a few boards left.  This board has 3 State Variable filters on 
it, 3 diode wave shapers, intended for shaping control voltages, and a 6 
input mixer that is connected to the Low Pass and Band Pass outputs of each 
filter (with a cut and a jump, you could change one of those to High Pass)...

This board also teaches you what Bypass Capacitors are for :-)

At 12:46 AM 2/27/2005 -0800, crystal wrote:
>as y'all can probably tell by this, my third post tonight, i am about to
>start to DIY again (finally).
>
>for my first real project in a few years i am considering building a dual
>VCF module with the capabilities for VC Band Width, VCcenter freq tracking
>maybe with INVERT option on one VC, and maybe some built in overdrive too.
>HP/BP on one, BP/LP on the other.
>
>any comments from those who have done this (or something similar)?
>
>any neat ideas?

         -Jim
***************************************************************
http://www.oldcrows.net/~patchell

***************************************************************