[sdiy] Omeg pot brackets

[Tom Arnold]

Anyone know of a source for the Omeg metal pot brackets that normally
shipped with Oakley kits?

I finally got that TB3031 working.  Had to audit every resistor on the
board.  Mostly it was just 22ohm resistors where 2k2's should have been.
Incorrect switches installed, wrong LEDs installed, backwards diodes, and
the worlds worst soldering job on some of the pot brackets that actually
managed to get the front panel to +12v.  Was so satisfying to make it work
however that in the end it was all worthwhile :-)

So I started looking at the TB3030 boards and found that one has brackets
and one doesnt so thats now on my list of things to aquire as I start the
build-out of my own dual 3030...

-- 
 -----------------------------------------------------------------
 - Tom Arnold       -  Free Synth DIY webspace http://www.sdiy.org 
 - SynthGeek        -
 - BBD Fanatic      -  "...is it a virus, a drug, or a religion?" 
 - echo evho wjxo   -    Juanita Shrugs. "What's the difference?" 
 --------------------