[sdiy] restoring an sh1000

[Fredrik Carlqvist]

I have a service manual but no original SH-1000 to look at. I will check if
there's a wiring diagram for the transformer. Should it be wired for 110V or
220V?

Fredrik C


-----Original Message-----
From: owner-synth-diy at dropmix.xs4all.nl
[mailto:owner-synth-diy at dropmix.xs4all.nl] On Behalf Of Brett Maddaford
Sent: den 12 april 2005 03:09
To: DIY
Subject: [sdiy] restoring an sh1000

Hi All
 
I picked up a damaged sh1000 a while ago for really good price and by luck
the other day got a new timber case for it so cosmetically its looking good.
Unfortunately when it was damaged the transformer ripped loose inside and i
cant see where to mount it is the first thing also it damaged wires
connected to the fuse at the rear (round plastic thingy with solder tabs) so
there are some free wires floating around. Apart form that the two 4 pin
connectors that run from the pcb under the front panel to the right side of
the pcb in the bottom of the case have come off and im not sure which one
connects where. if anyone has any idea of which one goes where and where the
transformer should be mounted and what wires connect where to the fuse id be
really appreciative if you could let me know or if you have a wiring diagram
forward it on or let me know where i can look at it.
 
The other thing i noticed is the transformer seems to be wired into the
copper coils....is this normal? or has it maybe been modified?
 
Thanks
Brett