[sdiy] Looking for alu stompbox manufacturer!

[Harry Bissell Jr]

A majority of stompboxes rely on the pots, switches,
or jacks to retain the PCB.  In the MXRs they were
attached with flexible wire and wrapped in soft
foam...

H^) harry


--- karl dalen <dalenkarl at yahoo.se> wrote:
> Im aware of Farnell and suppliers like they, the
> problem is that
> most diecast boxes they carry has either inmodled
> PCB card rails on the sides
> wich is usless for me, or they dont have inmolded,
> incasted bottom 
> PCB distances wich forces me to drill at least 4
> holes on bottom wich 
> becomes the top when finnished, then put in plastic
> or brass distances,
> All that is an extra work for me and "ugglifying"
> the finnished box.
> 
> Regards
> KD
>  
> --- Peter Cornell <peterc at onwe.co.za> wrote:
> > Go to www.farnell.com & do a search for "diecast'.
> > 
> > This will bring up a number of aluminium boxes
> that will be suitable for 
> > pedals. Farnell are in most of Europe too.
> > 
> > Peter
> > 
> > 
> > ----- Original Message ----- 
> > From: "karl dalen" <dalenkarl at yahoo.se>
> > To: <synth-diy at dropmix.xs4all.nl>
> > Sent: Monday, April 11, 2005 4:40 PM
> > Subject: [sdiy] Looking for alu stompbox
> manufacturer!
> > 
> > 
> > > Looking for alu stompbox manufacturer =
> anywhere!
> > > Looking for alu stompbox supplier = europe,
> scandinavia!
> > >
> > > Reg
> > > KD 
> > 
> > 
>