[sdiy] Differences between MG-1 and Rogue filters

[Metrophage]

--- Paul Schreiber <synth1 at airmail.net> wrote:
> This is a common Moog 'trick', even the Moog 904s use the
> base input resistance as "high enough for rock and roll".

Hi Paul!
I wonder if I am misunderstanding you. I'd assume that by "base input
resistance" you are referring to those same 200 ohm or 1k resistors
whos value you said doesn't matter, am I wrong? As in the bases of the
transistors? 

Why do the two schematics say that the signal strengths would vary so
much there, less than a volt compared to +/-12v? Is this related to the
filter rocking harder? I fear that I am high enough to rock, but no so
high that I can't see that my foundation in electronics is a tad
nonexistant, so I am not sure!

CJ



		
__________________________________
Do you Yahoo!?
Take Yahoo! Mail with you! Get it on your mobile phone.
http://mobile.yahoo.com/maildemo